Size / Design Variable
Pipe Diameter
Costing Variable
(Built-in Model)
Pipe Diameter, Pipe Length
Costing Variable
(User-Defined Model)
Pipe Length in m
Emissions Port
No
Hosts
Discrete Transport by Pneumatic Conveyor Procedure
|
|
Size / Design Variable |
Pipe Diameter |
|
Costing Variable |
Pipe Diameter, Pipe Length |
|
|
Costing Variable |
Pipe Length in m |
|
|
Emissions Port |
No |
|
|
Hosts |
Discrete Transport by Pneumatic Conveyor Procedure
|
A Pneumatic Conveyor (Discrete Flow) is used to represent an equipment resource used to host a conveying procedure with the objective to transport discrete entities with pressurized gas. The procedure can be executed in a batch or continuous mode.
See Pneumatic Conveyor (Bulk Flow): Equipment Tab.
In Calculate (Design Mode), the user specifies the Maximum Pipe Diameter and the system computes the Number of Units and the Pipe Diameter. The pipe cross sectional area (and consequently the pipe diameter) is calculated by dividing the operating throughput (MT/h) by the specific throughput (MT/h-m2). If the calculated pipe diameter exceeds the maximum, the system assumes multiple, identical units operating in parallel with a total cross sectional area equal to the calculated.
In User-Defined (Rating Mode), the user specifies the Number of Units and the Pipe Diameter and the system calculates the specific throughput. The user always specifies the pipe length and the system always calculates the operating throughput.
Equipment purchase cost is based on the pipe diameter, the pipe length and material of construction. It is supplied by the built-in model assuming as material of construction CS.