The following table shows the meaning of the variables appearing in this tab, as well as their default values and their generally acceptable range. Note that due to the manner by which the variables are used by the sizing and costing equations, the range of acceptable values may be further reduced.
|
Variable |
Default Value |
Range |
|
|
||
|
◙ Rated Throughput |
0.0 entity/h |
Positive |
|
◙ Max Throughput |
720,000 entity/h |
Positive |
Symbol Key: ○ User-specified value (always input); ● Calculated value (always output); ◙ Sometimes input, sometimes output
In Calculate (Design Mode), the user specifies the Maximum Throughput and the system computes the Number of Units and the Rated Throughput. If the operating throughput exceeds the maximum throughput, then the system assumes multiple identical units operating in parallel with an operating throughput of less than the maximum.
In User-Defined (Rating Mode), the user specifies the Number of Units and the Rated Throughput. If the operating throughput exceeds the rated throughput of the step (which is equal to the rated throughput of each unit times the number of units), a warning message is displayed advising the user to increase the number of units or reduce the operating throughput.
The equipment purchase cost supplied by the built-in model is zero, however the user may specify his own costing model if he wishes.
For more information on this equipment, see Discrete Flow Splitter.
For information on the left-hand side variables and options, see Equipment Data Dialog: Equipment tab.